Skip to main content
Ch. 7 - Linkage and Chromosome Mapping in Eukaryotes
Klug - Essentials of Genetics 10th Edition
Klug10th EditionEssentials of GeneticsISBN: 9780135588789당신이 사용하는 게 아니라요?교과서 변경
7장, 문제 14b

In Drosophila, a cross was made between females—all expressing the three X-linked recessive traits scute bristles (sc), sable body (s), and vermilion eyes (v)—and wild-type males. In the F1, all females were wild type, while all males expressed all three mutant traits. The cross was carried to the F2 generation, and 1000 offspring were counted, with the results shown in the following table.
Table showing offspring counts for eight phenotypes from a Drosophila cross involving three X-linked recessive traits.
No determination of sex was made in the data.
Determine the sequence of the three genes and the map distances between them.

검증된 단계별 안내
1
Step 1: Identify the parental and recombinant phenotypes. The two most frequent phenotypes represent the parental (non-recombinant) classes, while the less frequent phenotypes are recombinant classes. From the table, the highest counts are 314 (sc s v) and 280 (+++), so these are the parental phenotypes.
Step 2: Determine the double crossover classes. The two least frequent phenotypes correspond to double crossovers. From the table, these are 10 (sc s +) and 14 (++ v). Identifying these will help us find the gene order.
Step 3: Establish gene order by comparing the double crossover phenotypes to the parental phenotypes. The gene whose allele differs in the double crossover classes compared to the parental types is the gene in the middle. For example, compare the double crossover phenotypes to the parental ones to see which gene changes.
Step 4: Calculate recombination frequencies between each pair of genes. Use the formula for recombination frequency (RF): \(\text{RF} = \frac{\text{Number of recombinant offspring between two genes}}{\text{Total number of offspring}} \times 100\) Sum the single and double crossover classes relevant to each gene pair to find the recombinant offspring counts.
Step 5: Convert recombination frequencies into map distances (in centiMorgans, cM). The distances between genes are approximately equal to the recombination frequencies (1% RF = 1 cM). Use these distances to draw the gene map with the correct gene order and spacing.

비슷한 문제에 대한 검증된 영상 답변:

이 영상 해법은 위 문제에 도움이 된다고 튜터들이 추천한 것입니다.
영상 길이:
2m
도움이 되었나요?

주요 개념

질문에 올바르게 답하기 위해 반드시 이해해야 하는 핵심 개념들은 다음과 같습니다.

X-linked Inheritance

X-linked inheritance refers to genes located on the X chromosome, which show distinct patterns of inheritance, especially in species like Drosophila. Males, having only one X chromosome, express recessive traits if they inherit the mutant allele, while females require two copies. Understanding this helps interpret the phenotypic ratios in crosses involving X-linked genes.
추천 영상:

Genetic Linkage and Recombination

Genetic linkage occurs when genes are close together on the same chromosome and tend to be inherited together. Recombination during meiosis can separate linked genes, producing recombinant offspring. The frequency of recombination between genes is proportional to their physical distance, which is used to create genetic maps.
추천 영상:
가이드 코스
07:33
Chi Square and Linkage

Three-Point Test Cross and Map Distance Calculation

A three-point test cross involves crossing an individual heterozygous for three genes with a homozygous recessive individual to analyze recombination events. By counting offspring phenotypes, one can determine gene order and calculate map distances using recombinant frequencies, which reflect the percentage of crossover events between gene pairs.
추천 영상:
가이드 코스
26:08
Trihybrid Cross
관련 실천
교과서 질문

In Drosophila, a cross was made between females, all expressing the three X-linked recessive traits scute bristles (sc), sable body (s), and vermilion eyes (v)—and wild-type males. In the F₁, all females were wild type, while all males expressed all three mutant traits. The cross was carried to the F₂ generation, and 1000 offspring were counted, with the results shown in the following table.

No determination of sex was made in the data. Calculate the coefficient of coincidence. Does it represent positive or negative interference?

909
views
교과서 질문

In a series of two-point mapping crosses involving five genes located on chromosome II in Drosophila, the following recombinant (single-crossover) frequencies were observed:

In another set of experiments, a sixth gene, d, was tested against b and pr:

Predict the results of two-point mapping between d and c, d and vg, and d and adp.

1231
views
교과서 질문

In Drosophila, a cross was made between females—all expressing the three X-linked recessive traits scute bristles (sc), sable body (s), and vermilion eyes (v)—and wild-type males. In the F1, all females were wild type, while all males expressed all three mutant traits. The cross was carried to the F2 generation, and 1000 offspring were counted, with the results shown in the following table.

No determination of sex was made in the data.

Using proper nomenclature, determine the genotypes of the P1 and F1 parents.

2076
views
교과서 질문

Drosophila melanogaster has one pair of sex chromosomes (XX or XY) and three pairs of autosomes, referred to as chromosomes II, III, and IV. A genetics student discovered a male fly with very short (sh) legs. Using this male, the student was able to establish a pure breeding stock of this mutant and found that it was recessive. She then incorporated the mutant into a stock containing the recessive gene black (b, body color located on chromosome II) and the recessive gene pink (p, eye color located on chromosome III). A female from the homozygous black, pink, short stock was then mated to a wild-type male. The F1 males of this cross were all wild type and were then backcrossed to the homozygous b, p, sh females. The F2 results appeared as shown in the following table. No other phenotypes were observed.

Based on these results, the student was able to assign short to a linkage group (a chromosome). Which one was it? Include your step-by-step reasoning.

3302
views
교과서 질문

Two different female Drosophila were isolated, each heterozygous for the autosomally linked genes b (black body), d (dachs tarsus), and c (curved wings). These genes are in the order d–b–c, with b being closer to d than to c. Shown here is the genotypic arrangement for each female along with the various gametes formed by both:

Identify which categories are noncrossovers (NCOs), single crossovers (SCOs), and double crossovers (DCOs) in each case. Then, indicate the relative frequency in which each will be produced.

906
views
교과서 질문

In Drosophila, a cross was made between females—all expressing the three X-linked recessive traits scute bristles (sc), sable body (s), and vermilion eyes (v)—and wild-type males. In the F1, all females were wild type, while all males expressed all three mutant traits. The cross was carried to the F2 generation, and 1000 offspring were counted, with the results shown in the following table.

No determination of sex was made in the data.

Are there more or fewer double crossovers than expected?

509
views