A 15-cm-long tendon was found to stretch 3.7 mm by a force of 13.4 N. The tendon was approximately round with an average diameter of 8.5 mm. Calculate Young’s modulus of this tendon.

검증된 단계별 안내

Step 1: Recall the formula for Young's modulus, which is defined as \( E = \frac{\sigma}{\epsilon} \), where \( \sigma \) is the stress and \( \epsilon \) is the strain. Stress is given by \( \sigma = \frac{F}{A} \), and strain is given by \( \epsilon = \frac{\Delta L}{L_0} \).

Step 2: Calculate the cross-sectional area \( A \) of the tendon, assuming it is approximately circular. The formula for the area of a circle is \( A = \pi r^2 \), where \( r \) is the radius. Convert the diameter of 8.5 mm to meters (\( r = \frac{8.5}{2} \times 10^{-3} \) m) and substitute into the formula.

Step 3: Compute the strain \( \epsilon \) using the formula \( \epsilon = \frac{\Delta L}{L_0} \). Here, \( \Delta L \) is the elongation (3.7 mm converted to meters) and \( L_0 \) is the original length of the tendon (15 cm converted to meters).

Step 4: Calculate the stress \( \sigma \) using the formula \( \sigma = \frac{F}{A} \), where \( F \) is the applied force (13.4 N) and \( A \) is the cross-sectional area calculated in Step 2.

Step 5: Substitute the values of \( \sigma \) and \( \epsilon \) into the formula for Young's modulus \( E = \frac{\sigma}{\epsilon} \) to determine the modulus of elasticity for the tendon.

비슷한 문제에 대한 검증된 영상 답변:

이 영상 해법은 위 문제에 도움이 된다고 튜터들이 추천한 것입니다.

영상 길이:

주요 개념

질문에 올바르게 답하기 위해 반드시 이해해야 하는 핵심 개념들은 다음과 같습니다.

Young's Modulus

Young's modulus is a measure of the stiffness of a material, defined as the ratio of tensile stress to tensile strain. It quantifies how much a material will deform under a given load, providing insight into its elastic properties. A higher Young's modulus indicates a stiffer material that deforms less under stress.

Tensile Stress

Tensile stress is the force applied per unit area of a material, typically measured in pascals (Pa). It is calculated by dividing the applied force by the cross-sectional area of the material. In the context of the tendon, it helps determine how much force is exerted on the tendon relative to its size.

Tensile Strain

Tensile strain is the measure of deformation representing the displacement between particles in a material when subjected to tensile stress. It is a dimensionless quantity calculated as the change in length divided by the original length. In this case, it indicates how much the tendon stretches relative to its original length when a force is applied.