Question 1

Which of the following best describes the primary purpose of staining bacterial cells in microbiology?

Accepted Answer

To improve contrast and enable visualization of cell morphology and arrangement

Question 2

A student prepares a bacterial smear but forgets to heat fix it before staining. What is the most likely consequence?

Accepted Answer

The cells may wash off the slide during staining and rinsing

Question 3

Which of the following statements correctly explains why bacterial cells take up basic stains?

Accepted Answer

Bacterial cell walls are negatively charged and attract the positively charged chromophores of basic stains

Question 4

A microbiologist uses an acidic dye to stain a bacterial sample. What is the expected result and why?

Accepted Answer

The background will be stained while the bacterial cells remain colorless because acidic dyes are repelled by the negatively charged cell wall

Question 5

Which of the following is a correct example of a basic stain used in direct staining?

Accepted Answer

Crystal violet

Question 6

What is the main chemical principle behind the interaction of stains with bacterial cells?

Accepted Answer

Ionic interactions between charged chromophores and oppositely charged cell components

Question 7

During the preparation of a bacterial smear, what could happen if you heat fix the slide before the smear is completely air dried?

Accepted Answer

The cells may be distorted or lysed due to rapid water evaporation

Question 8

Which of the following best describes the difference between direct (basic) and indirect (acidic) staining procedures?

Accepted Answer

Direct staining colors the cells, while indirect staining colors the background

Question 9

A student is using the oil immersion objective (100X) to observe a stained bacterial smear. What is the primary purpose of using oil with this objective?

Accepted Answer

To increase the numerical aperture and reduce light refraction, improving resolution

Question 10

Which of the following is NOT a correct step in the procedure for preparing a direct (basic) stain of a bacterial smear?

Accepted Answer

Apply an acidic dye such as eosin directly to the smear

Question 11

If a microbiologist uses only one stain in a staining procedure, what type of staining is being performed?

Accepted Answer

Simple staining

Question 12

Which of the following best describes the process of 'fixing' bacterial cells to a slide?

Accepted Answer

Killing and adhering the cells to the slide by heat or chemical treatment

Question 13

A slide is prepared using the indirect (acidic) staining method. Which of the following best describes the appearance of the cells and background under the microscope?

Accepted Answer

Cells are clear, background is colored

Question 14

Which of the following is a potential problem if a bacterial smear is too thick when preparing a slide for staining?

Accepted Answer

The cells may not stain evenly, making it difficult to observe individual cell morphology

Question 15

Which of the following equations best represents the relationship between resolution ($$d$$), wavelength ($$\lambda$$), and numerical aperture ($$NA) in $$light microscopy?

Accepted Answer

$$d = \frac{\lambda}{2NA}$$

Question 16

A student stains a bacterial smear with nigrosin and observes the slide under the microscope. Which staining technique has the student performed, and what is the expected result?

Accepted Answer

Indirect (negative) staining; background is colored, cells are clear

Question 17

Which of the following is a correct sequence of steps for preparing a bacterial smear for direct staining?

Accepted Answer

Air dry, heat fix, apply stain

Question 18

Why is it important to use only a small amount of bacterial culture when preparing a smear for staining?

Accepted Answer

To allow individual cells to be observed clearly without overlap

Question 19

A clinical microbiologist needs to determine the shape and arrangement of bacteria in a patient sample. Which of the following steps is essential for accurate observation under the microscope?

Accepted Answer

Using a simple stain and focusing under the oil immersion objective

Question 20

Which of the following is a plausible reason for a bacterial smear appearing washed out and faint after staining?

Accepted Answer

The smear was not heat fixed, causing cells to wash off during staining

Microbiology Study Guide: Bacterial Staining and Microscopy

스터디 가이드 - 연습 문제

학습 가이드 - 플래시카드