Skip to main content
Ch. 30 - Inductance, Electromagnetic Oscillations, and AC Circuits
Giancoli Douglas - Physics for Scientists and Engineers 5th edition
Giancoli Douglas5th editionPhysics for Scientists and EngineersISBN: 9780137488179당신이 사용하는 게 아니라요?교과서 변경
29장, 문제 81

An inductance coil draws 2.2 A dc when connected to a 45-V battery. When connected to a 60.0-Hz 120-V (rms) source, the current drawn is 3.8 A (rms). Determine the inductance and resistance of the coil.

검증된 단계별 안내
1
Step 1: Understand the problem. The coil has both resistance (R) and inductance (L). When connected to a DC source, only the resistance affects the current. When connected to an AC source, both resistance and inductive reactance (X_L) affect the current. Use this information to set up equations for R and L.
Step 2: Use Ohm's Law for the DC circuit. The current in the DC circuit is given by I = V / R. Rearrange this to find the resistance: R = V / I, where V = 45 V and I = 2.2 A.
Step 3: For the AC circuit, calculate the total impedance (Z). The relationship between voltage, current, and impedance in an AC circuit is given by V_rms = I_rms * Z. Rearrange to find Z: Z = V_rms / I_rms, where V_rms = 120 V and I_rms = 3.8 A.
Step 4: Relate impedance (Z), resistance (R), and inductive reactance (X_L). In an AC circuit, the impedance is given by Z = √(R² + X_L²). Use the value of R from Step 2 and the value of Z from Step 3 to solve for X_L: X_L = √(Z² - R²).
Step 5: Calculate the inductance (L) using the formula for inductive reactance: X_L = 2πfL, where f = 60.0 Hz. Rearrange to find L: L = X_L / (2πf). Use the value of X_L from Step 4 to determine L.

비슷한 문제에 대한 검증된 영상 답변:

이 영상 해법은 위 문제에 도움이 된다고 튜터들이 추천한 것입니다.
영상 길이:
6m
도움이 되었나요?

주요 개념

질문에 올바르게 답하기 위해 반드시 이해해야 하는 핵심 개념들은 다음과 같습니다.

Inductance

Inductance is a property of an electrical component, typically a coil, that quantifies its ability to store energy in a magnetic field when an electric current flows through it. It is measured in henries (H) and is crucial in AC circuits, as it affects how the current and voltage relate to each other over time, particularly in response to changes in current.
추천 영상:
가이드 코스
12:59
Mutual Induction

Ohm's Law

Ohm's Law states that the current (I) flowing through a conductor between two points is directly proportional to the voltage (V) across the two points and inversely proportional to the resistance (R) of the conductor. This fundamental relationship is expressed as V = IR, and it is essential for analyzing both DC and AC circuits, allowing for the calculation of current, voltage, or resistance when the other two quantities are known.
추천 영상:
가이드 코스
03:07
Resistance and Ohm's Law

RMS Current and Voltage

RMS (Root Mean Square) values are used to express the effective value of alternating current (AC) and voltage. The RMS value of an AC signal is equivalent to a DC value that would deliver the same power to a load. Understanding RMS is vital for analyzing AC circuits, as it allows for the comparison of AC and DC quantities and is used in calculations involving power and impedance.
추천 영상:
가이드 코스
07:14
RMS Current and Voltage
관련 실천
교과서 질문

An ac voltage source V = Vo sin (ωt + 90°) is connected across an inductor L and current I = Io sin (ωt) flows in this circuit. Note that the current and source voltage are 90° out of phase.

(a) Directly calculate the average power delivered by the source over one period T of its sinusoidal cycle via the integral P = ∫₀ᵀ VI dt/T.

(b) Apply the relation P = Iᵣₘₛ Vᵣₘₛ cos Φ to this circuit and show that the answer you obtain is consistent with that found in part (a). Comment on your results.

1411
views
교과서 질문

In some experiments, very tiny distances or spaces ( ≈ nm ) can be measured by using capacitance. Consider forming an LC circuit using a parallel-plate capacitor with plate area A, and a known inductance L. If charge is found to oscillate in this circuit at frequency f = ω/2π when the capacitor plates are separated by distance x, show that x = 4π² Aε₀f²L.

1008
views
교과서 질문

A pair of straight parallel thin wires, such as a lamp cord, each of radius r, are a distance 𝓁 apart and carry current to a circuit some distance away. Ignoring the field within each wire, show that the inductance per unit length is (μ₀/π) ln[(𝓁 - r) /r].

1577
views
교과서 질문

In some experiments, very tiny distances or spaces ( ≈ nm ) can be measured by using capacitance. Consider forming an LC circuit using a parallel-plate capacitor with plate area A, and a known inductance L. When the plate separation is changed by ∆x, the circuit’s oscillation frequency will change by ∆f. Show that ∆x/x ≈ 2(∆f/f).

883
views
교과서 질문

Show that the fraction of electromagnetic energy lost (to thermal energy) per cycle in a lightly damped (R² ≪ 4L/C) LRC circuit is approximately ΔUU=2πRLω=2πQ\(\frac{\Delta U}{U}\)=\(\frac{2\pi R}{L\omega}\)=\(\frac{2\pi}{Q}\). The quantity Q can be defined as Q = Lω/R, and is called the Q-value, or quality factor, of the circuit and is a measure of the damping present. A high Q-value means smaller damping and less energy input required to maintain oscillations.

1560
views
교과서 질문

For an underdamped LRC circuit, determine a formula for the energy U = UE + UB stored in the electric and magnetic fields as a function of time. Give answer in terms of the initial charge Qo on the capacitor.

1631
views