(III) A 120-V rms 60-Hz voltage is to be rectified with a full-wave rectifier as in Fig. 40–40, where R = 24 kΩ, and C = 35 μF. (a) Make a rough estimate of the average current. (b) What happens if C = 0.10 μF? [Hint: See Section 26–5.]

검증된 단계별 안내

Step 1: Understand the problem. A full-wave rectifier converts an AC voltage into a DC voltage. The capacitor smooths the rectified voltage, and the resistor determines the current. The given parameters are: RMS voltage (V_rms) = 120 V, frequency (f) = 60 Hz, resistance (R) = 24 kΩ, and capacitance (C) = 35 μF (or 0.10 μF for part (b)). The goal is to estimate the average current and analyze the effect of changing the capacitance.

Step 2: Calculate the peak voltage (V_peak) of the AC source. The relationship between RMS voltage and peak voltage is given by:

V peak = V rms * \sqrt{2}

. Substitute V_rms = 120 V to find V_peak.

Step 3: Estimate the average current (I_avg) using the relationship between the load resistor (R) and the rectified DC voltage. The average current can be approximated as:

I avg = V peak / R

. Substitute the values of V_peak and R = 24 kΩ to calculate I_avg.

Step 4: Analyze the effect of the capacitor (C) on the smoothing of the rectified voltage. The capacitor smooths the voltage by reducing the ripple. The ripple voltage (ΔV) can be approximated using the formula:

∆V = I avg / (f * C)

. Substitute the values of I_avg, f = 60 Hz, and C = 35 μF to estimate the ripple voltage.

Step 5: Repeat the calculation of ripple voltage (ΔV) for C = 0.10 μF. Compare the results to understand how reducing the capacitance increases the ripple voltage, leading to less effective smoothing of the rectified voltage.

비슷한 문제에 대한 검증된 영상 답변:

이 영상 해법은 위 문제에 도움이 된다고 튜터들이 추천한 것입니다.

영상 길이:

10m

도움이 되었나요?

주요 개념

질문에 올바르게 답하기 위해 반드시 이해해야 하는 핵심 개념들은 다음과 같습니다.

RMS Voltage

RMS (Root Mean Square) voltage is a statistical measure of the magnitude of a varying voltage. It represents the equivalent DC voltage that would deliver the same power to a load. For an AC voltage, the RMS value is calculated as the peak voltage divided by the square root of two. Understanding RMS voltage is crucial for analyzing AC circuits, especially when converting to DC using rectifiers.

Full-Wave Rectification

Full-wave rectification is a process that converts both halves of an AC waveform into a unidirectional output. This is typically achieved using a bridge rectifier, which allows current to flow during both the positive and negative cycles of the input voltage. The result is a smoother DC output compared to half-wave rectification, making it essential for applications requiring stable voltage.

Capacitance and Filtering

Capacitance in a rectifier circuit acts as a filter to smooth out the output voltage. A capacitor charges during the peaks of the rectified voltage and discharges during the troughs, reducing voltage fluctuations. The value of the capacitor significantly affects the output ripple voltage; a larger capacitance results in less ripple, while a smaller capacitance, like 0.10 μF, can lead to a more pronounced ripple and less stable output.