Guida verificata passo dopo passo
04:00
06:18[Use of Tech] Analysis of a separable equation Consider the differential equation yy'(t) = ½eᵗ + t and carry out the following analysis.
a. Find the general solution of the equation and express it explicitly as a function of t in two cases: y > 0 and y < 0.
{Use of Tech} Torricelli’s law An open cylindrical tank initially filled with water drains through a hole in the bottom of the tank according to Torricelli’s law (see figure). If h(t) is the depth of water in the tank for t≥0 s, then Torricelli’s law implies h′(t)=−k√h, where k is a constant that includes g=9.8m/s², the radius of the tank, and the radius of the drain. Assume the initial depth of the water is h(0)=Hm.
a. Find the solution of the initial value problem.
17–20. Increasing and decreasing solutions Consider the following differential equations. A detailed direction field is not needed.
a. Find the solutions that are constant, for all t ≥ 0 (the equilibrium solutions).
y'(t) = (y−2)(y+1)
33–36. {Use of Tech} Computing Euler approximations Use a calculator or computer program to carry out the following steps.
a. Approximate the value of y(T) using Euler’s method with the given time step on the interval [0,T].
y′(t) = -2y, y(0) = 1; Δt = 0.2, T = 2; y(t) = e⁻²ᵗ
38–43. Equilibrium solutions A differential equation of the form y′(t)=f(y) is said to be autonomous (the function f depends only on y). The constant function y=y0 is an equilibrium solution of the equation provided f(y0)=0 (because then y'(t)=0 and the solution remains constant for all t). Note that equilibrium solutions correspond to horizontal lines in the direction field. Note also that for autonomous equations, the direction field is independent of t. Carry out the following analysis on the given equations.
a. Find the equilibrium solutions.
y′(t) = 2y + 4
46–48. Analyzing models The following models were discussed in Section 9.1 and reappear in later sections of this chapter. In each case, carry out the indicated analysis using direction fields.
Drug infusion The delivery of a drug (such as an antibiotic) through an intravenous line may be modeled by the differential equation m′(t)+km(t)=I, where m(t) is the mass of the drug in the blood at time t≥0, K is a constant that describes the rate at which the drug is absorbed, and I is the infusion rate. Let I=10mg/hr and k=0.05 hr^−1.
a. Draw the direction field, for 0≤t≤100, 0≤y≤600.
