What is the equivalent resistance between points 1 and 2 in FIGURE EX28.27?

검증된 단계별 안내

Step 1: Identify the configuration of resistors in the circuit. The circuit contains resistors in series and parallel combinations. Specifically, the 60 Ω and 40 Ω resistors are in parallel, while the 16 Ω, 25 Ω, and 35 Ω resistors are in series with the equivalent resistance of the parallel combination.

Step 2: Calculate the equivalent resistance of the 60 Ω and 40 Ω resistors in parallel using the formula for parallel resistance:

R_{eq} = \frac{1}{\frac{1}{R_{1}}}

, where R₁ = 60 Ω and R₂ = 40 Ω.

Step 3: Add the equivalent resistance of the parallel combination to the resistors in series. The total equivalent resistance is given by:

R_{total} = R_{eq} + 16 + 25 + 35

Step 4: Perform the addition of the resistances step by step. First, calculate the equivalent resistance of the parallel combination, then add the series resistances.

Step 5: Verify the result by ensuring all resistances are accounted for and the calculations follow the rules for combining resistors in series and parallel.

비슷한 문제에 대한 검증된 영상 답변:

이 영상 해법은 위 문제에 도움이 된다고 튜터들이 추천한 것입니다.

도움이 되었나요?

주요 개념

질문에 올바르게 답하기 위해 반드시 이해해야 하는 핵심 개념들은 다음과 같습니다.

Equivalent Resistance

Equivalent resistance is the total resistance of a circuit that can replace multiple resistors. It simplifies the analysis of complex circuits by allowing us to treat them as a single resistor. The equivalent resistance can be calculated differently for resistors in series and parallel, affecting how current flows through the circuit.

Series and Parallel Resistors

Resistors can be connected in series or parallel, which affects the total resistance. In a series connection, the total resistance is the sum of individual resistances, while in a parallel connection, the total resistance can be found using the formula 1/R_total = 1/R1 + 1/R2 + ... + 1/Rn. Understanding these configurations is crucial for calculating equivalent resistance.

Ohm's Law

Ohm's Law states that the current (I) through a conductor between two points is directly proportional to the voltage (V) across the two points and inversely proportional to the resistance (R). It is expressed as V = IR. This fundamental law is essential for analyzing circuits and understanding how voltage, current, and resistance interact.